On Router R1, process EIGRP 1 is redistributing routes from process OSPF 2, calling route
A. show ip route
B. show ip eigrp topology
C. show ip ospf topology
D. show ip eigrp topology 10.1.1.0/24
A. show ip route
B. show ip eigrp topology
C. show ip ospf topology
D. show ip eigrp topology 10.1.1.0/24
第1题
A. Router R1 will deny the 172.16.1.0/26 route while permitting the 172.16.1.64/27 route to be advertised.
B. Router R1 will advertise both rou tes.
C. Router R1 should be reconfigured with an ACL instead of an ip prefix - list command.
D. Router R1 will deny the 172.16.1.0/27 route while permitting the 172.16.1.0/26 route to be advertised.
第2题
A. R1(config)# router eigrp 1 R1(config - router)# passive - interface serial 0
B. R1(config)# access - list 2 0 deny any R1(config)# router eigrp 1 R1(config - router)# distribute - list 20 out serial 0
C. R2(config)# access - list 20 permit any R2(config)# router eigrp 1 R2(config - router)# distribute - list 20 in serial 0
D. R1(config)# access - list 20 permit any R 1(config)# router eigrp 1 R1(config - router)# distribute - list 20 in serial 0
E. R2(config)# access - list 20 deny any R2(config)# router eigrp 1 R2(config - router)# distribute - list 20 out serial 0
F. R2(config)# router eigrp 1 R2(config - router)# passive - interface serial 0
第3题
A. R1 is the router that redistributed the route
B. R1‘s metric to reach subnet 10.2.2.0/24 is 64
C. The route was redistributed on a router that has a router ospf 1 command configured
D. R1 is redistributing a route to prefix 1 0.2.2.0/24 into OSPF
第4题
某局域网通过两个路由器划分为三个子网,拓扑结构和地址分配如图1所示。
1.以下是路由器R1的部分配置命令列表:
Router>en
Router>conf term
Router (config) hostname R1
Router (config) int e0
R1 Router (config-if) (1)
R1 Router (config-if) no shutdown
R1 Router (config-if) (2)
R1 Router (config) ip routing
R1 Router (config) (3)
请为空缺处(1)、(2)、(3)添加合适的命令/参数,实现R1的正确配置。
2.以下是路由器R2的配置命令列表:
Router>en
Routerconf term
Router (config) hostname R2
R2 (config) int e0
R2 (config-if) ip address 192.168.3.1 255.255.255.0
R2 (config-if) no shutdown
R2 (config-if) int s0
R2 (config-if) ip address l92.168.2.2 255.255.255.0
R2 (config-if) no shutdown
R2 (config-if) (4)
R2 (config) ip routing
R2 (config) ip route 0.0.0.00.0.0.0 (5)
R2 (config) ip classless
R2 (config) exit
R2copy run start
请为空缺处(4)、(5)添加合适的命令/参数,实现R2的正确配置。
第5题
A. R1 has been configured with an ip default- network 2.0.0.0 command.
B. R1 has been configured with an ip route 0.0.0.0 0.0.0.0 1.1.1.1 command.
C. R1 has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.
D. Another router has been configured with an ip default - network 2.0.0.0 command.
E. Another router has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.
第6题
A. Router R2 will be preferred because it has the higher neighbor IP address.
B. Router R2 will be preferr ed because its neighbor has a lower autonomous system number.
C. Router R1 will be preferred because it has a lower local preference.
D. Router R2 will be preferred because it has a higher local preference.
E. Router R1 will be preferred because its nei ghbor has the higher autonomous system number.
F. Router R1 will be preferred because it has the lower neighbor IP address.
第7题
A.只允许192.168.4.2的数据流穿过R1
B.只允许192.168.4.2对R1进行TELNET
C.只允许192.168.4.2对R1进行TELNET 并拒绝其它流量
D.只允许192.168.4.0/24网段的数据流穿过R1
第8题
请阅读以下R1的配置信息,并补充【6】~【10】空白处的配置命令或参数。按题目要求完成R1的正确配置。
Router>enable
Router
Routerconfigure terminal
Router(config)
Router(config)hostname R1
R1(config)interface f0/1
R1(config-if)ip address 202.206.16.1 255.255.255.0
R1(config-if)no shutdown
R1(config-if)interfacef0/2
R1(config-if)ip adress 202.206.17.1 255.255.255.0
R1(config-if)no shutdown
R1(config-if)exit
R1(config)
R1(config)interface s1
R1(config-if)vlan ip adress 202.112.41.144 255.255.255.252
R1(config-if)bandwidth 【6】 配置带宽为2.048Mbps
R1(config-if)【7】 PPP 封装PPP协议
R1(config-if)noshutdown
R1(config-if)exit
R1(config-if)iproute 【8】 配置缺省路由
R1(config-if)router rip
R1(config-router)network 【9】 配置参与RIP的网络
R1(config-router)network 【10】 配置参与RIP的网络
R1(config-router)end
R1write
R1
第9题
A. R1 will always choose the route through R22.
B. As long as R1‘s best internal OSPF cost to reach R22 is less than 10.
C. As long as R1‘s best internal OSPF cost to reach R22 is less than 20.
D. R1 will never choo se the route through R22 if the E1 route through R2 is available.
第10题
A.The Mac address of the NIC in Sever1
B.The IP address of Server 1.
C.The MAC address of the s0/0/0 interface of router R2
D.The IP address of the s0/0/0 interface of router R1
E.The IP address of the Fa0/0 interface of router R1
第11题
A. The i su 10.1.0.0/23 route is a suppressed route.
B. The i su 10.1. 0.0/23 route is a summary route.
C. The i su 10.1.0.0/23 route is an IS - IS external route.
D. The R1 IS - IS router is an ASBR.
E. The R1 IS - IS router is an ABR that belongs to multiple IS - IS areas.
F. The R1 IS - IS router is performing route aggregation and is suppressing the more specific 10.1.0.0/23 prefix.
为了保护您的账号安全,请在“赏学吧”公众号进行验证,点击“官网服务”-“账号验证”后输入验证码“”完成验证,验证成功后方可继续查看答案!