What must be set correctly when configuring a serial interface so that higher-level protocols calculate the best route?()
A.bandwidth
B. delay
C. load
D. reliability
A.bandwidth
B. delay
C. load
D. reliability
第1题
A. ARCHIVELOG mode must be enabled
B. Row Movement must be enabled for the table
C. FLASHBACK must be set to ON for the database
D. The UNDO_MANAGEMENT parameter must be set to AUTO
E. The UNDO_RETENTION parameter must be set appropriately
第2题
A.Each end of the trunk line must be set to IEEE 802.1E encapsulation.
B.The VTP management domain name of both switches must be set the same.
C.All ports on both the switches must be set as access ports.
D.One of the two switches must be configured as a VTP server.
E.A rollover cable is required to connect the two switches together.
F.A router must be used to forward VTP traffic between VLANs.
第3题
A. You must set the vlan-tagging parameter under the [edit interfaces ge-0/0/1] hierarchy.
B. You must use the rename command to change unit 100 to unit 0.
C. You must set the encapsulation flexible-ethernet-services parameter under the [edit interfaces ge-0/0/1] hierarchy.
D. You must set the encapsulation vlan-ccc parameter under the [edit interfaces ge-0/0/1 unit 100] hierarchy.
第4题
A. Each end of the trunk line must be set to IEEE 802.1E encapsulation.
B. The VTP management domain name of both switches must be set the same.
C. All ports on both the switches must be set as access ports.
D. One of the two switches must be configured as a VTP server.
E. A rollover cable is required to connect the two switches together.
F. A router must be used to forward VTP traffic between VLANs.
第5题
A.Stop
B.Stop and wait until the seats are almost full
C.Go straight past
D.Not set off until it is full
第6题
A.The OSPF area is not configured properly.
B.The priority on R1 should be set higher.
C.The cost on R1 should be set higher.
D.The hello and dead timers are not configured properly.
E.A backup designated router needs to be added to the network.
F.The OSPF process ID numbers must match.
第7题
A.The command is accepted and the respective VLAN is added to vlan dat.
B.The command is rejected.
C.The command is accepted and you must configure the VLAN manually.
D.The port turns amber.
第8题
A. Set each end of the trunk line to IEEE 802.1Q encapsulation.
B. Set the same VTP management domain name on both switches.
C. Set all ports on the two switched as access ports.
D. Configure one of the two switches as a VTP server.
E. Connect the two switches using a rollover cable.
F. Use a router to forward VTP traffic between the VLANs.
第9题
第10题
A.The root account must be in order to utilize programs set this way
B.These permission in a program in a program can temporarily grant root privileges to anyone
C.SUID programs are not removed immediately from the swap/paging area, which results in a clear security risk
D.The SGID is a clear violation of good security practice and is only used as a result of the SUID
为了保护您的账号安全,请在“赏学吧”公众号进行验证,点击“官网服务”-“账号验证”后输入验证码“”完成验证,验证成功后方可继续查看答案!